SWISSREX retaining clip (c)

Retaining clip SWISSREX (spare part "c")
The holding clamp allows clamping of at least 10mm (0.3937") to a maximum of 67mm (2.6378") - without pressure plate up to max. 72mm (2.83465") .

Further information on using the retaining clips can be found in the operating instructions.

Notes:
If your workbench top is thickerthickness, or if you want to fix the System-Workshop directly to a wallwall as an auxiliary intermediate element, attach an appropriate 4 cm and a maximum thickness of 67 mm flush with the top of the workbench flush with the top of the workbench in front of the workbench or directly to the wall at the desired height, either horizontally or vertically, depending on use.

If the workpiece is longer than the workbench:
A squared timber or metal profile of the correct length and thickness can also be used if required, extend the existing workbench,
Then clamp the squared timber or metal profile to the workbench with screw clamps and attach the System-Workshop SWISSREX to the ends of the squared timber or metal profile. any desired length.
This construction (when not clamped to the workbench) also gives the System-Workshop SWISSREX the function of a screw clamp of any size. function of a screw clamp of any size!Important: in this function, select the squared timber or metal profile of the correct thickness!

Please note:
Many photos showApplication pictures including the basic device System-Workshop SWISSREX.
The System-Workshop and the respective accessories as well as any other tools and machines must be ordered separately.